Renewable sol-gel carbon ceramic electrodes modified with a Ru-complex for the amperometric detection of l-cysteine and glutathione

A renewable three-dimensional chemically modified carbon ceramic electrode containing Ru [(tpy)(bpy)Cl] PF₆ was constructed by sol-gel technique. It exhibits an excellent electro-catalytic activity for oxidation of l-cysteine and glutathione at pH range 2-8. Cyclic voltammetry was employed to characterize the electrochemical behavior of the chemically modified electrode. The electrocatalytic behavior is further exploited as a sensitive detection scheme for l-cysteine and glutathione by hydrodynamic amperometry. Optimum pH value for detection is 2 for both l-cysteine and glutathione. The catalytic rate constants for l-cysteine and glutathione were determined, which were about 2.1×10³ and 2.5×10³ M⁻¹ s⁻¹, respectively. Under the optimized condition the calibration curves are linear in the concentration range 5-685 and 5-700 μM for l-cysteine and glutathione determination, respectively. The detection limit (S/N=3) and sensitivity is 1 μM, 5 nA/μM for l-cysteine and 1 μM, 7.8 nA/μM for glutathione. The relative standard deviation (RSD) for the amperogram's currents with five injections of l-cysteine or glutathione at concentration range of linear calibration is <1.5%. The advantages of this amperometric detector are: high sensitivity, good catalytic effect, short response time (t<3 s), remarkable long-term stability, simplicity of preparation and reproducibility of surface fouling (RSD for six successive polishing is 3.31%). This sensor can be used as a chromatographic detector for analysis of l-cysteine and glutathione.     

Preparation and characterization of NiFe bimetallic micro-particles and its composite with silica shell

Magnetic NiFe particles were synthesized through hydrothermal method using hydrazine as reductant. Composite particles with core-shell structure were further achieved by depositing silicon dioxide generated via carbonation decomposition of sodium silicate solution on the surface of magnetic cores. Characterized by XRD, the Ni₉Fe particles are of fcc-type structure, and the structure of magnetic cores in composite particles was maintained despite being covered by SiO₂ shell. The existence of SiO₂ shells in the composite particles were demonstrated by SEM, EDS and IR. The results from TG and VSM indicated that the shell structure affected the physiochemical properties. The composite particles exhibited remarkable resistance to oxidation in comparison with Ni₉Fe particles due to being protected by SiO₂ shell. Meanwhile, both of them are soft magnetic materials, but Ms, Mr and Hc in Ni₉[email protected]₂ particle decreased compared with magnetic NiFe particles. The formation mechanisms of Ni₉Fe micro-particles and composite Ni₉Fe particles were discussed.     

锂离子电池用纳米Sn/SnSb合金三维复合负极的制备及性能

采用多步电沉积法制备的三维多孔铜箔作为集流体、低温液相化学还原法制备的纳米Sn/SnSb 合金作为负极材料, 制备出一种新型三维多孔结构的纳米Sn/SnSb合金复合负极. 通过与普通负极电化学性能的对比实验发现, 这种新型三维复合负极具有如下优点: 三维多孔网络结构提高了负极活性材料与集流体之间的结合力, 使不含粘结剂电极的制备成为可能; 有效缓解了高容量负极活性材料在充放电过程中的体积膨胀, 提高了负极活性材料的循环性能, 当循环到第30周时, 普通负极剩余容量为初始容量的33%, 而三维复合负极剩余容量为初始容量的41%; 三维铜箔集流体的特殊结构为高容量负极活性材料提供了一个良好的导电环境, 使电极反应进行得更加完全, 从而获得了更高的电极比容量, 普通负极初始容量为480 mAh·g-1, 而三维复合负极达到了800 mAh·g-1. 纳米Sn/SnSb合金三维复合负极良好的电化学性能为锂离子电池负极结构的设计开发提供了新的思路.     

SO2存在下钠、钙、铁及其复合物对NO-半焦反应的催化作用

采用程序升温还原技术，在SO2存在气氛下，对钠、钙、铁及其复合物的NO-半焦催化反应性能进行了研究。结果表明，在相同条件下三种金属对NO-半焦反应的催化活性顺序为：Fe>Ca>Na。SO2可能通过参与氧传递过程来影响金属对NO-半焦反应的催化活性。SO2的浓度对负载三种不同金属半焦催化活性的影响是不同的。SO2浓度对负载钠半焦的催化活性影响最为显著。在SO2存在气氛下，负载2％钠或铁和负载3％钙的半焦具有高的NO转化活性。在SO2存在气氛下，钠－钙和钠－铁二元金属复合催化剂的活性较高，这可能是由于这两种金属间存在协同作用的缘故。     

细乳液聚合法制备磁性复合微球及其表征

在制备超细Fe3O4 磁性粒子的基础上 ,以 3种低分子量聚合物Disperbyk 1 0 6、Disperbyk 1 0 8和Disperbyk 1 1 1为Fe3O4 微粒在单体相中的分散稳定剂 ,采用细乳液聚合法制备了平均粒径为 3 40nm的PS Fe3O4 磁性复合微球 .详细研究了分散剂种类对细乳液聚合制备磁性复合微球的影响 ,并采用XRD、TGA和TEM等手段对磁性复合微球的形态、结构及磁响应性等进行了表征 .实验结果证明分散剂的选择对磁性复合微球的成功制备起着至关重要的作用 ,兼具酸性和碱性功能基的分散剂Disperbyk 1 0 6具有更好的分散和稳定效果 .TEM结果表明 ,所制备的复合微球具有一些缺陷 ,而缺陷处往往是Fe3O4 磁性粒子聚集的地方     

磁性纳米TiO2/Fe3O4光催化复合材料的制备及性能

采用溶胶-凝胶法，在磁性Fe3O4表面包覆TiO2，制备了一种新型纳米TiO2/Fe3O4光催化复合材料．XRD，TEM对材料形态结构及包覆情况的分析，显示TiO2包覆在Fe3O4表面，形成平均尺寸为35～50nm的复合结构；UV-vis吸收曲线表明，复合材料对光的吸收出现红移，吸收强度增大；对染料废水光催化降解的模拟研究表明，该复合材料对活性艳红染料的脱色率达100％，是一种便于回收、可重复使用的高效光催化剂．     

Mass transfer determining parameter in facilitated transport through di-(2-ethylhexyl) dithiophosphoric acid activated composite membranes

Activated composite membranes (ACMs) containing di-(2-ethylhexyl) dithiophosphoric acid (D2EHDTPA) as a carrier have been found to facilitate the transport and separation of several cations. This paper describes an approach to the chemical characterisation of the transport phenomena of Zn²⁺, Cd²⁺, Cu²⁺, Ni²⁺, Sn²⁺ and In³⁺ by an ACM. The selectivity of D2EHDTPA based ACM towards different metal ions is presented and discussed focusing in Zn²⁺ and Cd²⁺ transport and recovery. Selectivity demonstrates that zinc ions are removable from mixtures due to the different extraction strength of D2EHDTPA. Such selectivity is based on the differences of the dynamic behaviour of the metal ions transport. In addition, a correlation of the chemical behaviour of those ACM systems with the corresponding solvent extraction systems has been found.     

Sulfonated poly(ether ether ketone)/polyaniline composite proton-exchange membrane

Sulfonated poly(ether ether ketone) (PEEK) was prepared by sulfonation of commercial Victrex^@ PEEK and degree of sulfonation was found to be about 44.5% by ¹H NMR. Sulfonated PEEK/polyaniline composite membranes, in order to prevent methanol crossover, were prepared by chemical polymerization of a thin layer of polyaniline (PANI) in the presence of a high oxidant concentration on a single face modification. FTIR and PANI coating density studies confirmed the loading of PANI in sulfonated PEEK membrane matrix. PANI composite membranes with different polymerization time were prepared and subjected to thermogravimetric analysis as well as electrochemical and methanol permeability study to compare with sulfonated PEEK and Nafion 117 membrane. Ion-exchange capacity, water uptake, proton transport numbers and proton conductivities for different PANI composite sulfonated PEEK (SPEEK) membranes were found to be dependent on the coating density of the PANI in the membrane matrix and were slightly lower than that of Nafion 117 membrane. Methanol permeability of these membranes (especially SPEEK/PANI-1.5) was about four times lower than Nafion 117 membrane. Among the all SPEEK membranes synthesized in this study, SPEEK-1.5 appears to be more suitable for direct methanol fuel cell (DMFC) application considering optimum physicochemical and electrochemical properties, thermal stability as well as very low methanol permeability. Above all, the cost-effective and simple fabrication technique involved in the synthesis of such composite membranes makes their applicability quite attractive.     

Influence of Cycle Temperatures on the Thermochemical Heat Storage Densities in the Systems Water/Microporous and Water/Mesoporous Adsorbents

The adsorption equilibrium of water on microporous adsorbents (zeolites of NaA-, NaY- and NaX-type as well as their ion exchanged forms) and on mesoporous adsorbents (different silica gels and composite material i.e. silica gel + salt hydrate) has been studied experimentally and theoretically. Using the Dubinin theory of pore filling the characteristic curves of the adsorption systems and other relevant dependences such as isotherms, isobars, isosteres and the curve of the differential heat of adsorption were calculated. For all systems investigated the adsorption were calculated. A_ads and the desorption potential A_des of the closed heat storage system were estimated. These values define the working range of the adsorption/desorption cycle and allow to calculate the specific heat storage density Δ h_sp. On the basis of Δ h_sp the different adsorbents were compared in order to select the optimal porous storage material for a given application. The presented experimental and theoretical investigations show that the adsorption systems water-zeolite and water-composites are promising working pairs for thermochemical heat storage processes for hot tap water supply and space heating of single family dwellings. The advantage of the water-composite system is the low desorption temperature (solar energy) the main shortcoming the low temperature lift. The advantage of the water zeolite system is the high temperature lift, the shortcoming are the relative high desorption temperatures.     

Simultaneous determination of ascorbic acid, uric acid and neurotransmitters with a carbon ceramic electrode prepared by sol-gel technique

A sol-gel carbon composite electrode (CCE) has been prepared by mixing a sol-gel precursor (e.g. methyltrimethoxysilane) and carbon powder without adding any electron transfer mediator or specific reagents. It was demonstrated that this sensor can be used for simultaneous determination ascorbic acid, neurotransmitters (dopamine and adrenaline) and uric acid. Direct electrochemical oxidation of ascorbic acid, uric acid and catecholamines at a carbon composite electrode was investigated. The experimental results were compared with other common carbon based electrodes, specifically, boron doped diamond, glassy carbon, graphite and carbon paste electrodes. It was found that the CCE shows a significantly higher of reversibility for dopamine. In addition, in comparison to the other electrodes used, for CCE the oxidation peaks of uric acid, ascorbic acid and catecholamines in cyclic and square wave voltammetry were well resolved at the low positive potential with good sensitivity. The advantages of this sensor were high sensitivity, inherent stability and simplicity and ability for simultaneous determination of uric acid, catecholamines and ascorbic acid without using any chromatography or separation systems. The analytical performance of this sensor has been evaluated for detection of biological molecules in urine and serum as real samples.